PASI GEA RM1 1.0, User Manual

Page: 32 / 71

28
-> Execute / Modify or Execute / Modify / Repeat: the command allows to enter in a
further menu that will allow: the fullfillment of the measure under examination,
overwriting the results already obtained if present; the change of the geometric values
associated with the electrodes; the repetition of a measurement by varying the positions
of the electrodes M and N (only for sessions performed with the Schlumberger method
and only for the last measure acquired correctly). By carrying out the command, you enter
the execution / modification window and possibly repeat the measurement (see paragraph
Execution, editing and repetition of a measure in session ).
-> Previous measure: allows the scrolling of the lines of the session by displaying, in the
same way, the previous measure contained in the session.
The following lines show all the parameters relating to the measure under examination:
- Position of the electrodes, or indication "TBD" (To Be Defined) if the position has not
yet been entered, or indication "TBM" (To Be Measured) if you are using a session with
the Schlumberger method and the positions of the electrodes have not yet been calculated.
-
Measured electrical parameters, or indication of parameters not present via "-".
-
Sigma value percentage of the measurement performed, or indication of parameter
not present via "-".
-
Date and time of execution of the measure, or indication of information not
present via "-".
Execution, editing and repetition of a measure in session
The window allows to perform the operations indicated on the data related to a single
measure of the session.
F
IGURE
21 -
EXECUTION COMMAND OF THE MEASSURE IN
SESSION