2
USER MANUAL SYSTEM RF200click
1. Guarantee conditions
The manual has been prepared to be used by quali
fi
ed workers and cannot be used by people who are not entitled.
Should any questions or doubts occur, you are requested to contact PASEDO company. The manual presents correct
way of montage of garage door hardware only. In order to assembly a garage door with sandwich panel and other
devices, the producer should follow manuals of the sandwich panel and other devices. The sandwich panel and other
devices should be produced according to European Union rules.
2. Assembly conditions
Unprofessional assembly, any variations of the assembly that are not in accordance with this manual, will be made on
the garage door Producer’s responsibility. This also applies to any damages caused by improper use and not following
the rules of this manual as well as improper service. The system presented in this manual should be used in residential
buildings only and can be assembled and run by quali
fi
ed workers only.
- The garage door can be assembled and put into operation by quali
fi
ed workers only.
- Make sure that during working with electric devices the power is o
ff
.
- Security devices should never be switched o
ff
!
- Be careful in case of keen edges, use gloves.
- If visible damages of security device occur, stop further using of the door.
- While assembly/maintenance of the door it is recommended to always use gloves and protection shoes, and during
drilling use the protection glasses.
- Make sure that works are carried out in a stable environment.
- Mark out the place of working with a tape so that the children and other people keep a distance.
- The maintenance to be carried out by a professional company or person only.
- Provide su
ffi
cient lighting.
- Use the suitable tools, especially for springs torsioning.
3. Control and service just after assembly
When assembly is
fi
nished worker should control if all elements are mounted in accordance with the manual, properly
tightened as well as they should provide:
- lubrication of shaft bearings and rollers,
- lubrication of hinges,
- lubrication of steel cable,
- placement of Identi
fi
cation Card and required warning labels.
4. Passing the
fi
nished product to customer
Producer of door passes it to a user and shows him the way of working of the product, instructs him how to use the door
and provide the following documents:
- manual of use and service,
- instructions what to do in case of incorrect working of door.
5. Garage door maintenance and overview
Door overview shall be signed in Door Service Book.
After 3 months since door assembly, assembling person (service person) makes:
- visual control of all elements,
- control of proper door operating and tightening the fasteners if needed.
After 6 months or after 700 cycles the user shall:
- remove impurities from door that have in
fl
uence on correct working of door,
- lubricate the bearings and rollers,
- lubricate the hinges.
After 12 months since assembly repairer (assembling person) shall control and maintenance of proper door operating:
- roller (damages, material consumption, lubrication),
- control of steel cables consumption, especially connections with cable drums and bottom brackets and working places
of cable pulleys if applied,
- control of cable pulleys consumption, if applied,
- spring break device control,
- control of horizontal track connection with ceiling,
- control of shaft brackets,
- control of seals (top, bottom and side) consumption and damages
- control of shaft coupler, if applied.
6. Garage door operator
All electric devices (including operators) that are a part of garage door shall ful
fi
ll requirements of European Union
standards. Assembly of operator shall be made in accordance with operator’s producer’s manual. In case of lack of power
supply or if there is no separate entrance into the garage, door shall be equipped with drive releaser.
