4)Cabinet Assembly Instructions
A. Installing the Crossovers
To mount the crossovers we recommend using hot glue due to its faster setup time. If you use RTV sealant,
you may need to let it setup over night, before proceeding with the assembly.
Left and Right Speakers: Mount the crossover on the back of the cabinet between the two woofer openings
directly behind the tweeter hole. Feed the input wire through the opening in the back of the cabinet. Remove
excess wire and then strip and tin the wire ends. Solder wire ends to the terminal cup while observing proper
polarity. The positive (+) wire goes to the red terminal and the negative (-) goes to the black. Orient the
terminal cup, so that the binding posts are toward the bottom of the cabinet. Install the terminal cup using
the #6 (small) screws. Tighten the screw only until the terminal cup is flush with the back of the cabinet.
Do not over tighten the screws!
Page 6
