RP-700User’s Manual
Paper roll specification: paper roll OD Max ф83 mm, core ID Min. ф12
.8mm
Paper recommended:
Paper model
Manufacturer
600-3.1
APPLE TON Papers Inc
KLS_46_e
KANZA N Spezialpapiere GmbH
FD210
OJ I Paper CO., LTD.
Table 2.3-1 Recommended thermal paper model
2.3.2 Parameters of marked paper
RP-700 can support marked paper printingand set the cutting and initial printing position
accurately. The marked paper not only should meet the specifications of thermal paper roll, but
also should meet the following requirements:
L1 mark height:
3mm≤ L1≤13
mm
L2 mark length:
L2≥8mm
L3 distance between two marks:
30mm≤L3<450mm
Thermal side mark sensor position: reserved the left/middle/right positions
Non-thermal side mark sensor position: the middle/left/right positionis selectable
Reflectivity: The reflectivity of the black mark must be no more than 15% while the reflectivity
of the paper itself should exceed 85%. There should be no image between the two marks,
such as the advertisement, etc.
Caution:
Please use the recommended paper or its equivalents. Using the paper of low quality might
affect the print quality and shorten the lifetime of print head;
Do not stick paper onto the core shaft;
If the paper is contaminated by chemical or oil, it may discolor or lose heat sensitivity at the
polluted spot, which will affect the print affect;
Do not rub the paper surface with hard objects, otherwise it may affect the print affect;
When the environment temperature goes up to 70
℃
, paper will discolor. Thus don not use or
store paper under high temperature, high humidity and strong light conditions.
The mark is measured during printing and paper feeding. If the mark height value detected
by the sensor is bigger than the default value (default setting is 13mm), the printer will alarm
paper end.
- 4 -
