Driver and Lamp operating temperature
Both the led bar heatsink and led driver both operate at about 25 deg. C or 45 F
above ambient temperature. So at 25 degrees C or 77 F room temp the driver and
heatsink will be about 50 deg. C or 122 F. This is perfectly normal and safe.
To minimise the temperature locate the driver down low at the air intake and
have the out take moving air across the heatsink.
If the driver case temperature gets to 90 DegC or 195 F the output current will be
reduced. If the temperature does not reduce then it powers off until
temperatures have reduced.
Maintenance
The MIGRO grow light system requires almost no maintenance. In ordinary use
the only maintenance required is to keep the heatsink and the LED surface clean.
This will ensure the cooling performance and light output are maintained,
respectively.
To clean all of the components switch off the power and use warm water and
soap with a damp cloth. Do not under any circumstances use a solvent, acid
based or an abrasive cleaner on any of the components. Doing so may damage
the finish of the product and the LEDs.
General specifications
The MIGRO ARAY 120W module is a II bar
LED grow light with a single driver and a
3.5M long cable.
●
Flowering coverage: up to 60cm x 60cm (2ft x 2ft)
●
Vegging coverage: up to 90cm x 90cm (3ft x 3ft)
By Partech LED Ltd
www.migrolight.com
13
