5. Attach the filter assembly to the bracket so that the fuel hoses are attached to the filter
assembly. Run the engine and check the filter and lines for leaks.
3.4 Inspecting idling speed
A diagnostic tachometer should be used for this procedure. Results may vary depending on
whether testing is conducted with the flushing attachment in a test tank, or with the outboard motor in
the water.
1. Start the engine and allow it to warm up fully in neutral until it is running smoothly.
2. Verify whether the idle speed is set to specification.
Idle speed
：
750±50Rpm
CAUTION:
Correct idling speed inspection is only possible if the engine is fully warmed up. If not
warmed up fully, the idle speed will measure higher than normal. If you have difficulty
verifying the idle speed, or the idle speed requires adjustment, consult a PARSUN dealer or
other qualified mechanic.
33
