Step 3.
Step 4.
Step 5.
Lift the antenna and remove the protective backing from the underside of the antenna and place the antenna back in
the desired position. Apply downward pressure on the antenna to stick it to the panel. This step is optional if you plan
on mounting the antenna magnetically.
To avoid the gap between the antenna and panel, it is reccomenended to use neutral cure silicon sealant around the
base of the mounting boot to fully compress the antenna to the mounting panel.
A split flat washer and a split hex nut are provided in the kit for easy installation.
(Star washer is optional and not supplied. Part Number:
PTA0251
)
On the inside of the vehicle, thread the flat washer over the cable, followed by star washer (if applicable) and then hex
nut. (Figure 2 & 3)
Slide the washers and nut to the threaded flange of the antenna and tighten the hex nut until antenna compresses flat
with the surface of the vehicle.
(Figure 4)
FIGURE 3
FIGURE 4
FIGURE 2
Roof
Split Washer
Split Hex Nut
Step 1.
Step 2.
Route the cable from the antenna to the router by maintaining a minimum bend radius of 0.5in. Avoid sharp bends.
Run the cables adjacent to existing wiring.
Waterproof the RF connectors using electrical tape or a heat shrink tube, if required.
Routing the Cables
