Akita Installation Instructions
Page 7 of 8
Routing the Cable
1.
Properly route the cables, making sure there are no sharp bends. Clamp the cables to the wall at
about 6 inches away from the antenna if the cables are being hung straight from the wall.
2.
Make sure the antenna is mounted in the correct direction and tighten the mounting hardware.
Waterproof the RF connectors using electrical tape, or a heat shrink tube.
Cable Connection Instructions
Step 1:
Use canned air and/or isopropyl alcohol to clean all the connectors to ensure that there is no dust in the
terminals.
Step 2.
Connect the antenna cables to the designated terminals on the router, as shown in the tables and images
below
S. No
Cable from Antenna
Connector on Router
1
CELL 1
MAIN0
2
CELL 2
AUX0
3
CELL 3
MAIN1
4
CELL 4
AUX1
5
GPS
GPS
6.0 inches
Clamp the cables
For best MIMO performance, use the following in pairs:
CELL 1 & CELL 2
CELL 3 & CELL 4
