Distributing International, Inc.
www.NiceStuffOnline.com
[email protected]
34 SOUTH FEDERAL HIGHWAY, SUITE A
DANIA BEACH, FL 33004
Tel. (954)929-2524 Fax (954)929-2455
1.
BASIC INSTALLATION WITH ISO CONNECTORS
Installation in a Car with Radio with ISO sockets
(see Diagram)
1. Disconnect the speaker harness and the power harness from the back of the car radio
2. Connect the mute cable and power cable female connectors to the back of the radio
3. Connect the speaker harness to the black male connector of the mute cable
4. Connect the power harness to the gray male connector of the power cable
5. If the car radio has a Mute input, connect the isolated yellow wire of the mute cable to one of
the cables labeled “Mute In 1”, “Mute In 2”, “Mute In 3” of the power cable. Consult the car
radio manual to determine the location of the mute input.
Important
:
The red wire on the power cable must be connected to the co12V (battery wire)
The orange wire must be connected to the sw12V (ignition wire)
The black wire must be connected to the electrical ground
Check the electrical diagram of the ISO power harness.
On some vehicles, the pin assignments of the battery wire and of the ignition wire are
switched. The positions of the red and orange wires must be inverted. It is done by
opening the fuse holders, and switching the two wires.
Do not connect the orange wire to the co12V (battery wire), you run the risk of
draining the battery.
Check that the red and green lights go on and off with the ignition.
