36
Safety
Through Safety preferences, you can set a safe and clear flying area for
Thermal.
Set
Thermal
’s maximum flight altitude with the “Max altitude” slider.
This setting is
always activated, regardless of the activation of the Geofence.
To set a maximum distance from the pilot for your drone, move the “Max distance” slider to
the required value, then tap YES to activate the Geofence. When the Geofence is activated,
Thermal will automatically stop when it reaches the maximum distance you have
selected.
-
Max altitude
0m to 150m (DV: 30m)
-
Max distance
10m to 4000m (DV: 100m)
-
Geofence
NO / YES
-
Minimum altitude when
20m to 100m (DV: 30m)
using RTH
Tap “RESET ALL
SAFETY
PREFERENCES”
on the bottom of the page to reset preferences.
Camera
Camera preferences enable you to select camera options, both in photo and video modes.
-
Camera calibration
Tap
“CALIBRATE”
to access camera & gimbal calibration
-
Autorecord from take-off
NO/ YES (video only)
-
Lossless zoom only
NO / YES
(selecting “YES” blocks zoom in JPEG RECT)
-
Display overexposure
NO / YES
-
Anti-flickering
OFF / AUTO / 50Hz / 60 Hz
About camera calibration: only resort to
the “correct horizon”
procedure if you notice your
videos and photos are systematically tilted on the same side. Refer to the “
Camera
calibration
” section of this guide for the detailed procedure.
About overexposure display: when this setting is activated, the HUD of FreeFlight 6 shows all
overexposed areas of the screen as hatched, which enables you to fine-tune your framing,
your EV settings, or both.
About Anti-flickering: this setting and the associated technology aim at eliminating the flicker
effect which can arise due to some artificial
lights. The “AUTO” option should work for most
users, but depending on your country, you can try other settings if you feel bothered by a
flicker effect on your device
’s
screen, your artificial light videos, or both.
Tap “RESET ALL
CAMERA PREFERENCES AND SETTINGS
”
on the bottom of the page to reset
preferences (except for the Bracketing mode, which is only managed manually).
Network
Network preferences let you change your
Thermal
’s Wi
-Fi network name, password,
and band.