F62
92
Installation & Operating Instructions for the
Parrotuncle Owner’s Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
FAN INSTALLATION INSTRUCTIONS
Parrotuncle Lighting, 218 Black Tie Lane, Chapel Hill, NC
www.parrotuncle.com
Parrot Uncle YOU CAN BE SURE OF are trademarks of Eileen Grays LLC.
Used under license by Eileen Grays LLC.
All rights reserved.
Made in
CHINA
7
Lift motor assembly, aligning the keyhole
slots with the preassembled screws on
mounting plate, and twist clockwise till
lock. Reinstall the screws removed in
figure
4. Tighten all screws securely.
They should be in
a straight line.
hook
The hole near
the hook.
Installing
the housing
There are 4 screws on the hanging plate,
loosen 2 screws ,remove 2 screws . The motor
housing is directional, as shown in the picture.
Insert the wire first, then lock the motor
housing.
Attach housing onto
hang
ing plate,
aligning the
key
hole slots on the housing
with the screws on mounting plate and
twist clockwise till tight. Reinstall the
screw removed
previously
. Tighten all
screws securely.
Hanging plate
Housing
8
Installing the center band and blade
bracket
The three groups of holes in the center band are
aligned with the three groups of holes in the motor
shell.
Note: Do not lock the first blade bracket tightly,
because it may need to adjust the center band so
that the hole in the center band is aligned with the
hole in the motor shell when locking the second
blade bracket.
After all the blade brackets are installed, lock all
the screws tightly.
Center band
blade bracket
9