F628
6
Installation & Operating Instructions for the
Parrotuncle Owner’s Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
FAN INSTALLATION INSTRUCTIONS
WARNING
Make sure electricity is turned off at the main power box before commencing work. Turn off the power by removing fuse or turning off circuit breaker before installing the fan and replacing the lamps.
• The lowest point on the fan blade must be at least 2.1 metres (7 feet) from the floor.
• Make sure that ceiling joists are strong enough and of adequate size to support the weight of the fan of about 35 kg.
Parrotuncle Lighting, 218 Black Tie Lane, Chapel Hill, NC
www.parrotuncle.com
Parrot Uncle YOU CAN BE SURE OF are trademarks of Eileen Grays LLC.
Used under license by Eileen Grays LLC.
All rights reserved.
Made in
CHINA
Remove the
3
screws from the
switch housing
.
Connect the
single pin
wire
plugs
from the motor
housing to the wire
plugs
from the light kit
.
Attach
the switch housing cover
to the
switch
housing using
3
screws
removed previousl
y,
tighten them securely.
Attention should be paid to avoid the position of
the reverse switch
when locate the light kit
.
Rotate 3* E
26
bulbs (not included) into the lamp
holders .
(see below figure.)
reverse switch
switch housing
cover
switch housing
Install the glass onto the light kit and tighten
the washer and nut onto the bottom of
glass. Place decorative cap over the bottom
of glass and secure by tightening
decorative finial.
(see below two
figures
on
the right below
)
