Parrot Uncle BBHDA199A, Manual

Page: 10 / 14

WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
BBHDA199A
Installation & Operating Instructions for the
Parrot Uncle Owner's Installation, Manual
7
a. WARNING: Chemical Burn Hazard. Keep batteries away from children.
b) This product contains a lithium button/coin cell battery. If a new or used lithium button/coin cell
battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in
as little as 2 hours. Always completely secure the battery compartment. If the battery compartment
does not close securely, stop using the product, remove the batteries, and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
c) The cells shall be disposed of properly, including keeping them away from children; and
d) Even used cells may cause injury
25W 120 V 18W
yellow
White
Voltage Fan (max.) Lamp (max.)
Antenna wire
Ground wire
Power supply live-wire Light neutral-wire
Light live-wire
To Motor wire
Red
Gray
To Motor wire
To Motor wire
Power supply neutral-wire
Blue
5
6
WIRING SCHEMATIC DIAGRAM FOR RECEIVER
POWER PARAMETER LIST
FUNCTION INSTRUCTION OF EMITTER
KINDLY REMINDERS:
Green
White wire
Black wire
8
LED indicated light
Turn up the speed of the fan
Direction of the fan
(reverse switch)
Timing control of the fan
ON/OFF the fan
Turn down the speed of the fan
Short press: ON/OFF the light
Long press: Adjust the brightness
of the light
3V CR2032 battery X 1pcs
8
Adopt RF wireless digit emission technique, biunique controlled , coincident code rate is less than one
millionth. (Emitter and receiver must be sent back to factory for maintenance if damaged.)
Receiver can be controlled by any angles of the emitter in prescriptive space, unrestricted by direction.
With the memory function, the controller can save the status( light and direction ) while the supply
power OFF and resume to the original after reload the power supply.
1. If the emitter can not control the fan, learning code matching mode is used between emitter and receiver.
Turn “ON" the supply power within 30 seconds and press the emitter's “ ” button for 5 seconds, it can load
normally after hearing a long sound “bee”, which means learning successfully and it can works normally.
(PS: Learning mode is not accepted after turn “ON” the supply power for 30 seconds)
2. When the emitter cannot control the receiver, please check the battery switch touching normally or not, correction of the positive
and negative, full or empty of the power.
3. When the emitter cannot control the receiver, please check is there any existence of similar remote controlled products nearby,
then check whether they works, because remote controlled product with the same frequency will disturb each other.
4. Low voltage of battery will affect the sensitivity of the emitter and the signal reception accordingly(the indicated light will flash
out its warning when the battery get low voltage), must replace if the battery is getting low voltage.
5. Please take out the battery from the emitter when leaving unused for long time.
6. The maximum load of lighting see the above“POWER PARAMETER LIST”
PS: please connect the ground wire correctly, otherwise it may cause the light micro-light or flash
7. When installing the fan, the fan ceiling cover don't press the antenna (or other wire), it is easy to breakdown the wire and
short-circuited.
WIRING SCHEMATIC DIAGRAM FOR RECEIVER
POWER PARAMETER LIST
Green
White wire
Black wire