Parmco WM8WF, Installation And Operating Instructions Manual, Page: 20 / 22

Troubleshooting guide
1.
it is secure.
Check the connection and ensure
2. Change the temperature sensor.
1. The connection between the
temperature sensor and wire is
not secure.
2. The temperature sensor is damaged.
1. Check the connection and ensure
it is secure.
2. Change the heating tube.
1. The connection between the
heating tube and wire is not
secure.
2. The heating tube is damaged.
1. Check the connection and ensure
it is secure.
2. Check if the machine is overloaded.
Switch off the machine, and retry
when the motor becomes cool.
3. Change the motor.
1. The connection between the
motor and wire is not secure.
2. The motor is protected because
of over-heat.
3. The motor is damaged.
1. Change the water inlet.
2. Check the connection and ensure
it is secure.
3. Change the water sensor.
1. The water inlet valve is damaged.
2. The connection between the
water sensor and wire is not
secure.
3. The water sensor is damaged.
Possible Cause
The machine
fills overtime.
There is a Door
lock alarm.
1. Water tap is not open.
2. Drain hose is put down.
3. Water inlet valve is damaged.
1. Open the water tap.
2. Hook up the hose.
3. Change the water inlet valve.
“E01” is on the
screen.
Problem Error Code
The machine
drains overtime.
Water overflows
the machine.
/ Water sensor
works abnormal.
The motor does
not work.
There is a
heating tube
fault.
There is a
temperature
sensor fault.
1. Check the drain hose.
2. Clean the filter.
3. Check the drainage system
and clean it.
1. The drain hose is squashed
or kinked .
2. The drain pump filter is block.
3. The drainage
system pipes are
blocked .
1. Lock the door well.
2. Put the garment into the drum.
3. Change the door lock.
1. The door is not locked well.
2. Garments is caught between the
door and seal.
3. Door lock is damaged.
“E02” is on the
screen.
“E04” is on the
screen.
“E03” is on the
screen.
“E05” is on the
screen.
“E06” is on the
screen.
“E07” is on the
screen.
Difficult explanation
15 16
220-240V~;50Hz
2100W
0.02-0.8MPa
595X545X845mm
Technical Parameters
Model
Parameter
Power
Washing / spin capacity
Rated power
Water pressure
Net weight / gross weight
Outer dimension
(W x D x H)mm
Note:
Data can vary from the nominal values given depending on water pressure,
water hardness, water inlet temperate, room temperature, type and volume
of load, fluctuations in the electricity supply and any extra options seleceted.
Appendix
WM8WF
8kg
65kg/69kg
4. The motor is damaged. 4. Change the motor.
15