Compartment
A:
With each wash cycle.
Compartment
B:
For programmes with pre-wash only.
(Follow the
User Instructions)
Mechanical indicator
C.
Electric indicator on control panel (if provided).
Check the rinse aid level
Load the baskets
Select a programme
T urn on the water tap and press the
Start/Pause Button
. The machine will start working
after about 10 seconds.
Starting a programme
Switch off the appliance
Unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to breaking.
They will also dry better. Unload the appliance, starting from the lower basket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Close the door, press the Programme Button until the selected programme lights up.
(Check the Operating Instructions section)
When the working cycle has finished, the buzzer of the dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the appliance is switched
off during a wash cycle.
!
Open the door carefully
Hot steam may escape
when the door is opened!
WARNING!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state.
Switch on the appliance
Press the On/Off button to switch on the appliance. Open the door.
Quick operation guide
For detailed operating instructions, please read the corresponding section of this manual.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pause button, press the program button for more than three seconds,the
machine will be in standby state, then you can change the program to the desired cycle setting
1.Press the Start/Pause Button to stop the washing.
2.Open the door a little .
3.After the spray arms stop working, you can open the door
completely.
4.Add extra dishes.
5.Close the door.
6.Press the Start/Pause Button, the dishwasher will run again
after 10 seconds.
A
B
C