Parkside PWSAP 20-Li B2, Operation And Safety Notes

Page: 38 / 174

37 GB/IE
2) Operations such as sanding and
polishing are not recommended to
be performed with this power tool.
Operations for which the power tool was not
designed may create a hazard and cause
personal injury .
3)
Do not use accessories which
are not specifically designed
and recommended by the tool
manufacturer. Just because the accessory
can be attached to your power tool, it does
not assure safe operation .
4)
The rated speed of the accessory
must be at least equal to the
maximum speed marked on the
power tool. Accessories running faster
than their rated speed can break and fly
apart .
5) The outside diameter and the
thickness of your accessory must be
within the capacity rating of your
power tool.
Incorrectly sized accessories
cannot be adequately guarded or controlled .
6)
Threaded mounting of accessories
must match the grinder spindle
thread. For accessories mounted
by flanges, the arbour size hole of
the accessory must fit the locating
diameter of the flange. Accessories that
do not match the mounting hardware of the
power tool will run out of balance, vibrate
excessively and may cause loss of control .
7) Do not use a damaged accessory.
Before each use inspect the
accessory such as abrasive wheels
for chips and cracks, backing pad
for cracks, tear or excess wear,
wire brush for loose or cracked
wires. If power tool or accessory
is dropped, inspect for damage or
install an undamaged accessory.
After inspecting and installing an
accessory, position yourself and
bystanders away from the plane
of the rotating accessory and run
the power tool at maximum no‑
load speed for 1 minute. Damaged
accessories will normally break apart during
this test time .
8) Wear personal protective
equipment. Depending on
application, use face shield, safety
goggles or safety glasses. As
appropriate, wear dust mask,
hearing protectors, gloves
and workshop apron capable
of stopping small abrasive or
workpiece fragments. The eye
protection must be capable of stopping flying
debris generated by various operations . The
dust mask or respirator must be capable
of filtrating particles generated by your
operation . Prolonged exposure to high
intensity noise may cause hearing loss .