Parkside PWSA 20-Li C3, Translation Of The Original Instructions

Page: 18 / 140

PWSA 20-Li C3
GB
│
CY
│ 13 ■
With thick grinding discs (see fig. 2)
> 3,2 mm
Fig. 2
The collar of the clamping nut faces downwards
so that the grinding disk can be fitted securely onto
the attachment spindle .
♦ Lock the attachment spindle .
♦ Tighten the clamping nut in a clockwise
direction using the two-hole mounting
spanner .
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
♦ For safety's sake, run the appliance at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.
♦ Check whether all the fastening elements are
correctly fitted.
♦ Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough
grinding discs (including diamond cutting discs)
and the direction of rotation of the appliance
(arrow showing the direction of rotation on the
head) match.
Operation
Switching on and off
Check the attached tool before use to ensure that
all fastening elements are correctly fitted.
NOTE
► Always switch on the angle grinder before
making contact with the material, then apply
it to the workpiece.
► If the appliance blocks due to an overload
and switches off, it will restart automatically
as soon as the cause of the blockage is
removed (auto-start function).
Switching on
♦ First, press the ON/OFF switch to the right
so that you can then press it forwards.
Switching off
♦ Let go of the ON/OFF switch .
Switching to continuous operation
♦ First, press the ON/OFF switch to the right
so that you can then press it forwards. Then
press the
ON/OFF switch forwards and
down until it engages.
Switching off continuous operation
♦ Press the ON/OFF switch to the rear and
downwards and release it.
Adjusting the rotational speed
You can use the adjusting wheel for speed pre-
selection to preselect the rotational speed:
(1 = slower speed, 6 = faster speed).
We recommend you carry out practice tests to
determine the correct speed.
The speed can also be changed during operation.