Parkside PWSA 20-Li B3, Instructions Manual

Page: 17 / 134

PWSA 20-Li B3 ■ 12
│
GB
│
CY
♦ Undo the clamping nut using the two-hole
mounting spanner (see fig D).
♦ Place the rough grinding or cutting disc with the
label side towards the appliance on the attach-
ment flange .
♦ Then replace the clamping nut on the attach-
ment spindle with the raised side facing up.
With thin grinding discs (see fig. 1):
♦ The collar of the clamping nut faces upwards
so that a thin grinding disc can be fitted safely.
12
≤ 3,2 mm
Fig. 1
♦ Press the spindle locking button to lock the
motor.
♦ Tighten the clamping nut using the two-hole
mounting spanner .
With thick grinding discs (see fig. 2):
> 3,2 mm
Fig. 2
The collar of the clamping nut faces downwards
so that the grinding disk can be fitted securely onto
the attachment spindle .
♦ Lock the attachment spindle .
♦ Tighten the clamping nut in a clockwise di-
rection using the two-hole mounting spanner .
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
♦ For safety's sake, run the appliance at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.
♦ Check whether all the fastening elements are
correctly fitted.
♦ Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough grind-
ing discs (including diamond cutting discs) and
the direction of rotation of the appliance (arrow
showing the direction of rotation on the head)
match.
Operation
Switching on and off
Check the attached tool before use to ensure that
all fastening elements are correctly fitted.
NOTE
► Always switch on the angle grinder before
making contact with the material, then apply
it to the workpiece.
Switching on:
♦ First, press the ON/OFF switch to the right
so that you can then press it forwards.
Switching off:
♦ Let go of the ON/OFF switch .
Switching to continuous operation:
♦ First, press the ON/OFF switch to the right
so that you can then press it forwards. Then
press the
ON/OFF switch forwards and
down until it engages.
Switching off continuous operation:
♦ Press the ON/OFF switch to the rear and
downwards and release it.