Parkside PWS 230 B2, Instructions Manual, Page: 15 / 73

11 PWS 230 B2
GB
♦ Then replace the clamping nut , with its
raised side facing upwards, on to the mounting
spindle .
♦ Press the spindle lock button to block the drive.
♦ Tighten the clamping nut again with the Two-
pin spanner .
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must immediately
be replaced.
♦ For safety’s sake, run at high idle for 60
seconds after every disc change. Be aware of
unusual noises and sparks.
♦ Check whether all the fastening elements are
correctly fitted.
♦ Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough grind-
ing discs (including diamond cutting discs) and
the direction of rotation of the appliance (arrow
showing the direction of rotation on the head)
match.
Switching on and off
Check the accessory tool before use. It must be
properly installed, may not be damaged or damp,
should have no cracks and turn freely. Carry out
a 60 second test run. Do not use non-circular or
vibrating tools. Be aware of unusual noises and
sparks. Check whether all the fastening elements
are correctly installed.
Switching on:
♦ Press the safety lock-out (see Fig. E).
♦ Then press the ON / OFF switch .
Switching off:
♦ Release the ON / OFF switch .
Rotating the hand grip
■ The hand grip can be rotated by 90° to the
right or left (see Fig. A).
■ This allows the ON / OFF switch to be
brought into the most comfortable position for
any working conditions.
♦ Press the unlocking button and rotate the
hand grip to the right or left.
♦ Make sure the hand grip engages.
Maintenance and cleaning
WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any work.
■ Do not use any sharp objects to clean the
appliance. Never permit fluids to penetrate
inside the appliance.
The appliance could be
damaged. The carbon brushes should only be
replaced by the service centre or an authorized
specialist workshop. Apart from this, the appli-
ance is maintenance-free.
■ Clean the appliance regularly, preferably im-
mediately after completion of the work.
■ Clean the housing with a dry cloth – do NOT
use petrol, solvents or cleaners that can attack
the plastic.
■ A vacuum cleaner is required for thorough
cleaning of the appliance.
■ Ventilation openings must never be obstructed.
■ Remove any adhering swarf with a brush.
NOTE
► Unlisted replacement parts (such as carbon
brushes, switch) can be ordered via our
service hotline.
Disposal
The packaging consists of environmentally
friendly material. It can be disposed of in
the local recycling containers.
Do not dispose of power tools in
your normal domestic waste!
European Directive 2012/19/EU requires that
worn-out power tools be collected separately and
fed into an environmentally compatible recycling
process.
Your local community or municipal authorities can
provide information on how to dispose of the worn-
out appliance.