Parkside PWBS 180 B3, Translation Of The Original Instructions, Page: 15 / 53

PWBS 180 B3
GB
│
IE
│
NI
│
CY
│ 11 ■
Sanding close to the edge
If you are sanding close to the edge, you can
remove a hood segment of the protective and
suction hood . This means that the accessory tool
you are using is closer to floor, wall and ceiling
edges as well as existing installations such as
pipes, and the adjacent surfaces can be precisely
machined.
Expect dust to develop during this work, as the
protective and suction hood is no longer closed
off.
♦ Pull the hood segment forwards out of the
protective and suction hood .
♦ Work the surfaces close to the edge.
♦ Push the hood segment back into the suction
hood until it locks into place.
Operation
■ Tool direction of rotation!
Switching on
♦ To switch on the appliance, slide the On/Off
switch forwards.
To lock the On/Off switch , press the On/Off
switch down at the front until it clicks
into place.
Switching off
♦ To switch off the power tool, let go of the On/
Off switch . If it is locked, press the rear end
of the On/Off switch and then release it.
Setting the rotational speed
Before starting work, set the speed to suit the appli-
cation. Use a low speed for coarse sanding;
increase the speed for fine sanding.
■ Adjust the speed by pressing the buttons .
♦ Press the + button to increase the speed.
♦ Press the – button to decrease the speed.
NOTE
► The accessory tool rotates after switching off.
Wait until the accessory tool has come to a
standstill before putting down the appliance.