Parkside PTPK 270 A1, Translation Of The Original Instructions

Page: 22 / 118

22
GB
not to be repaired, but rather re-
placed by new ones. Have dam-
age on your equipment repaired
by an authorised specialist.
• Do not pull the plug from the
socket by the cable. Protect the
cable from heat, oil and sharp
edges.
• Do not carry or fi x the equip-
ment by the cable.
• Use only extension cables that
are protected from spray water
and designed for outdoor use.
Always fully unroll a cable
drum before use. Check the ca-
ble for damage.
• Disconnect the mains plug from
the socket before all work on
the equipment, in case of leaks
in the water system, during
work breaks, and when not in
use.
• The cross-section of extension
cords must be no smaller than
rubber hose lines with the des-
ignation H05RN-F. The cord
length must be at least 10 m. The
fl exible lead cross-section of
the extension cord must at least
2.5 mm
2
.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fi ed person in order to prevent
hazards.
Operational start-up
Assembly

To screw-on the adaptor:
1. Screw the angle adapter (10) onto the
pump outlet (4).
• Please read the notes in the op-
erating instructions on the topic
of “Maintenance and Cleaning”
and “Storage”. Any measures
above and beyond these,
particularly opening the equip-
ment, are to be carried out by
an electrician. In the case of
repairs, always contact our ser-
vice centre.
Electrical safety:
Caution: to avoid accidents
and injuries from electric
shocks:
• After installation, the mains plug
must be freely accessible when
the equipment is in operation.
• Before you put your new pump
into operation, have it checked
professionally if you are unsure
about:
- Grounding, zeroing, residual
currentt circuit breaking must be
compliant with the safety regula-
tions of the energy supply com-
pany and function without fault,
- The protection of the electrical
plug connections from the wet.
• If there is a risk of fl ooding, fi x
the plug connections in an area
that is safe from fl ooding.
Risk of electric shock.
• Ensure that the mains voltage
matches the specifi cations on
the rating plate.
• The electrical installation shall
be according to national wiring
rules.
• Before each use, check the
equipment, cable and plug for
damage. Defective cables are