11
1. Outlet
• Applies only when using as a hot air gun or soldering iron. Ensure the outlet (16) on
the hot air/soldering attachment is pointing upwards (away from the stand). Adjust the
position of the hot air/soldering attachment if necessary.
2. Push the flame regulator (5) to the maximum setting
3. Periodic operation
• Pull the ignition switch (7) to ignite the flame.
• Release the ignition switch to extinguish the flame.
4. Continuous operation
• Pull the ignition switch (7) to ignite the flame.
• Press the continuous operation switch (4) to lock the ignition switch in the pulled
position.
• Pull and release the ignition switch (7) to release the continuous operation switch and
extinguish the flame.
An irregular flame can be generated or gas can escape in fluid form if the gas soldering iron
is cold or has just been refilled. This is normal and does not indicate a fault. The flame will
stabilise once the device warms up (approx. 1-2 minutes).
Continuous flame
Regulating the flame
Igniting and extinguishing the flame
3
2
4
1
Igniting the flame