PSTK 800 B2
GB
│
IE
│
NI
│
7
■
Setting the pendulum stroke
♦
You can use the pendulum stroke switch to set
the pendulum movement of the saw blade .
You can achieve fine, clean cut edges without
pendulum movement (setting “0”) . Switch the
pendulum movement off when working on thin
workpieces . You can achieve an increasingly
fast workrate with activated pendulum stroke
(settings 1–3) .
Switching on/off
Switching the appliance on:
Slide the ON/OFF switch forward to the position “I” .
Switching the appliance off:
Slide the ON/OFF switch backward to the
position “0” .
Switching the laser/working light
on/off
On/off switch:
Press the ON/OFF switch until the required
function is active .
LASER and WORKING LIGHT → WORKING
LIGHT → LASER → SWITCH OFF
Sawdust blowing function
Switching the sawdust blowing function on:
♦
Slide the sawdust blower function switch in
the position
.
Supporting the extraction function:
♦
Slide the sawdust blower function switch in
the position “0” .
Maintenance and Cleaning
WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work.
■
The appliance must always be clean, dry and
free from oil or grease .
■
To clean the casing, use a soft dry cloth .
WARNING!
■
To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person .
■
Replace the saw blade as soon as its teeth
are blunt and proper sawing is therefore no
longer possible .
■
Clean the appliance after completing your
sawing work .
■
Remove any dirt (e .g . sawdust) . If necessary,
clean the saw blade mounting with a brush or
blow it out with compressed air .