PSSA 20-Li A1
GB
│
IE
│
NI
│
7
■
CAUTION!
♦
If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged .
♦
If the red and green control LEDs both
flash, this means that the battery pack is
defective .
♦
Push the battery pack into the appliance .
♦
Switch off the charger for at least 15 minutes
between successive charging sessions .
Also disconnect the power plug from the mains
power socket .
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Allow the battery pack to click into place in
the appliance .
Removing the battery pack:
♦
Press the release button and remove the
battery pack .
Checking the battery charge level
♦
Press the battery charge level button to check
the status of the battery (see also main diagram) .
The status will be shown on the battery display
LED as follows:
♦
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting/changing the saw blade
WARNING!
►
Remove the battery before carrying out
any work on the power tool (e.g. mainte-
nance, changing tools, etc.) as well as during
the transport and storage of the power tool.
Unintentional activation of the ON/OFF
switch can result in injury .
♦
Turn the quick-release chuck as far as the
stop and hold it in this position .
♦
Push the required saw blade into the
quick-release chuck as far as the stop .
CAUTION!
►
The teeth of the saw blade must point
downwards!
♦
Let go of the quick-release chuck so that it
returns to its initial position . The saw blade
is now locked .
