Parkside PSHL 2 A2, Operation And Safety Notes Translation Of The Original Instructions

Page: 13 / 49

GB/IE/NI 13
Cleaning and ... / Storage / Environmental instructions ... / Troubleshooting
z
Cleaning and Maintenance
z „
Do not use any harsh cleaning agents to
clean the helmet casing
2
.
z „
Never bring the UV filter
8
into contact
with water.
z „
Clean the product with a soft, dry
cloth, with a cloth dampened with pure
alcohol or with a cloth dampened with
disinfectant.
z
Storage
z „
Keep the device in a dry place and out of
the reach of children.
z
Environmental instructions
and disposal information
Don‘t waste, recycle!
The device, accessories and packaging
should be recycled in an environmentally
friendly manner.
Do not throw the auto-darkening welding
helmet into household rubbish, fire or water.
If possible, non-operational equipment should
be recycled. Contact your local retailer for
information.
z
Troubleshooting
Error Cause Solution
The filter does not darken in
a normal way or flickers.
The protector does not
darken in a normal way or
flickers.
Clean the protector or
replace it.
The arc sensor is not clear. Clean the arc sensor's
surface.
The welding current is
too low.
Set the sensitivity to the
maximum degree.
The reaction is slow. The ambient temperature is
too low / high.
Only use the welding
helmet in temperatures
between -5 °C and +55 °C.
The sensitivity is too low. Set the sensitivity to a
higher setting.
The visibility is poor. The protector / the protective
screen is dirty.
Clean the protector and the
protective screen.
The protective film on the
protective screen was not
removed.
Remove the protective film.
The ambient light is not
sufficient.
Apply more light to your
work surroundings.
The wrong darkening shade
has been set.
Reset the darkening shade.
The welding helmet slips.
The headband
5
has been
put on incorrectly.
Put on the headband
5
again tighter.