Parkside PSBM 1100, Operation And Safety Notes

Page: 8 / 10

10 GB/IE
Preselecting the rotation speed
You can preselect the required speed using the
speed preselector wheel
5
.
j
You can increase or decrease the speed by
turning the speed preselector wheel. The most
suitable speed depends on the material involved.
We recommend that you carry out a few
practical tests beforehand.
Tip:
You will always find these two basic guidelines
helpful:
1. Large drill diameter = lower speed whilst
smaller drill diameter = higher speed
2. Hard material = lower speed
Selecting the direction
of rotation
Caution! Only change the position of the rotation
direction switch after the tool has come to a standstill.
j
Set the direction you wish the drill to rotate by
using the rotation direction switch
6
.
Note: The tool operates at lower speeds when
rotating in the counter clockwise direction.
Selecting the gear
Caution!
The gear selector switch must only be
moved after the drill has come to a standstill.
j
Select between the following speed ranges
using the gear selector switch
7
:
1 = low speed range
2 = high speed range
Selecting drill / hammer
drill action
Caution! Only change the setting of the drill /
hammer drill action switch after the tool has come
to a standstill.
j
Select the appropriate operating mode using
the drill / hammer action selector switch
1
:
Drilling:
j
Set the switch 1 to the right on to the
drill symbol.
Hammer drilling:
j
Set the switch 1 to the left on to the
hammer symbol.
Note:
The hammer drill action mode is intended
for drilling into brick, concrete and stone only.
Maintenance and cleaning
Attention! Before carrying out any tasks on the
device itself and when you are not using the device,
always pull the mains plug out of the mains socket.
The device is largely maintenance-free.
j
Always keep the device and the ventilation
slots clean.
j
Clean the device frequently. For best results,
clean the device immediately after you have
finished using it.
j
Do not allow any liquids to enter the device.
Use a soft cloth to clean the device.
j
Do not under any circumstances use petrol or
strong solvents.
j
Store the device in a dry room.
Disposal
The packaging is wholly composed of
environmentally-friendly materials that
can be disposed of at a local recycling
centre.
Operation / Maintenance and Cleaning / Disposal