MAINTENANCE
OF THE CROSSCUT AND MITRE SAW
Before starting any work on the saw always pull the plug from the socket.
• The replacement carbon brushes (d) supplied may only be changed and fitted at an authorised repair centre.
• Clean the crosscut and mitre saw frequently. For the best results do this straight after the work has been completed.
• Do not allow liquids to get inside the saw. Use a soft cloth for cleaning the housing. Do not use petrol, solvents or cleaners
that might attack the plastic.
TIPS AND TRICKS
• If you often wish to use the saw in a lot of different places we recommend that you mount it on a 20mm thick plywood base. You can carry
the saw easily on this and attach it to many kinds of surfaces.
• Never position curved workpieces in such a way that they curve away from the stop plate. This creates a gap between the stop plate
and the workpiece, which could lead to the workpiece jamming during the cut.
• Cut a curved workpiece initially a little longer / larger than necessary and only after this should you cut it to the exact length required.
A large curve is always detrimental to accuracy.
• To improve safety, mount an additional wooden guide (75 x 500 x 12 mm) on the saw. There are some suitable holes provided on the stop
plate for this.
Further practical tips for power tools can be found in the accompanying booklet on safety advice.
We reserve the right to make technical modifications in the course of further development.
STATEMENT OF CONFORMITY
We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, Germany, hereby declare
that this product conforms with the following EC regulations:
EC low voltage regulations:
73/23 EEC, 93/68 EEC
Electromagnetic compatibility:
89/336 EEC
Applicable harmonised standards:
EN 55014-1: 1993+A1+A2, EN 61000-3-2: 1995+A1+A2,
EN 60555-3: 1987, EN 60555-3/A1: 1991, EN 55014-2: 1997
EN 61029-1: 1995, prEN 61029-2-9: 1994
Type:
PKGS 1400
Bochum, 30.07.2002
Hans Kompernaß
- Managing Director -
!
8
