13
PHS 160 B3
GB
are about to work on with liquids containing
solvents.
■
Do not abrade moistened materials or damp
surfaces.
■
Avoid sanding paints containing lead or other
substances hazardous to health.
■
Do not work on materials containing asbestos.
Asbestos is a known carcinogen.
■
Avoid contact with the moving sanding sheet.
■
Operate the device only with an attached sand-
ing sheet.
■
Never use the device for a purpose for which
it was not intended nor with non-original parts
/ accessories. The use of tools or accessories
other than those recommended in the operating
instructions could lead to you suff ering an injury.
■
Switch the device off and allow it to come to a
standstill before you put it down.
■
Always keep the device clean, dry and free of
oil or grease.
Preparing for use
CAUTION!
►
Make sure that the device is switched off
before you connect it to the mains supply.
NOTE
►
Always switch on the delta sander before
bringing it into contact with the workpiece
material.
Switching on the device:
♦
Push the ON / OFF switch into Position “I“.
Switching off the device:
♦
Push the ON / OFF switch into Position “0“.
Vacuum dust extraction
WARNING! DANGER OF FIRE!
►
There is the danger of fi re when working with
electrical devices that have a dust box or can
be connected to a vacuum cleaner. Under
certain conditions the wood dust in the dust ex-
traction bag (or in the vacuum‘s dust bag) may
ignite, e.g. as a result of fl ying sparks generated
when abrading metals or metal objects left in
wood. This can happen particularly if the wood
dust is mixed with paint residue or other chemi-
cals and the abraded particles are hot from
prolonged abrasion. Therefore you must empty
the device’s dust collection box and the vacuum
cleaner’s dust bag before taking a break or
stopping work and always avoid overheating of
the abraded particles and the device.
Wear a dust mask!
WARNING!
►
Always pull the mains plug is out of the socket
before doing any work on the device.
Dust box for internal
vacuum extraction
Mounting:
♦
Slide the dust box for self-generated dust extrac-
tion
b
up to the stop on the hand sander.
Removal:
♦
Press the release button of the dust extrac-
tion box for internal vacuum extraction
b
and
withdraw it towards the rear of the device.
NOTE
►
Empty the dust collector in good time in order
to ensure the optimum removal of
b
dust by
suction.
♦
To do so, remove the dust box
b
from the
device as described above. Open the dust box
by pulling on the tab
a
and remove the cover.
Now tap both parts to thoroughly clean them.
IB_100087_PHS160B3_LB1.indb 13
28.05.14 13:41
Summary of Contents for PHS 160 B3
Page 3: ...A B a b...