PFS 710 D3
GB
│
MT
│
37
■
Plunge sawing:
CAUTION! RISK OF KICKBACK!
■
Plunge cuts may only be made in soft
materials (wood or similar) .
Proceed as follows:
1 . Place the sabre saw with the lower edge of the
footplate onto the workpiece . Switch the
appliance on .
2 . Tilt the sabre saw forwards and plunge the saw
blade into the workpiece .
3 . Position the sabre saw vertically and continue
sawing along the cutting line .
Maintenance and cleaning
WARNING! RISK OF INJURY!
Always switch the appliance off
before carrying out any work on it.
■
Always remove the power plug from the power
socket before cleaning the appliance .
■
Replace the saw blade as soon as its teeth are
blunt and proper sawing is therefore no longer
possible .
■
Keep the appliance and ventilation slits clean at
all times . If the ventilation slits are blocked, there
is a risk of overheating and/or the appliance
being damaged .
■
Always clean the appliance after completion
of work .
■
Never permit liquids to enter inside the appli-
ance . Use a cloth to clean the housing . Never
use petrol, solvents or cleansers which can
damage plastic .
■
If necessary, clean the saw blade mount with a
brush or compressed air .
Kompernass Handels GmbH
warranty
Dear Customer,
This appliance has a 3-year warranty valid from
the date of purchase . If this product has any faults,
you, the buyer, have certain statutory rights . Your
statutory rights are not restricted in any way by the
warranty described below .
Warranty conditions
The validity period of the warranty starts from the
date of purchase . Please keep your original receipt
in a safe place . This document will be required as
proof of purchase .
If any material or production fault occurs within
three years of the date of purchase of the product,
we will either repair or replace the product for you
at our discretion . This warranty service is dependent
on you presenting the defective appliance and
the proof of purchase (receipt) and a short written
description of the fault and its time of occurrence .
If the defect is covered by the warranty, your product
will either be repaired or replaced by us . The repair
or replacement of a product does not signify the
beginning of a new warranty period .
Warranty period and statutory claims for
defects
The warranty period is not prolonged by repairs
effected under the warranty . This also applies to
replaced and repaired components . Any damage
and defects present at the time of purchase must
be reported immediately after unpacking . Repairs
carried out after expiry of the warranty period shall
be subject to a fee .
Summary of Contents for PFS 710 D3
Page 3: ......
