Parkside PFMR 1600 B2, Operation And Safety Notes Translation Of The Original Instructions

Page: 30 / 106

31 GB/IE
¾
We recommend using the original package
for storage or covering the product with
a suitable cloth or enclosure to protect it
against dust .
˜
Transportation
¾
Switch the product off and disconnect it from
the mains .
¾
Attach transportation guards, if applicable .
¾
Always carry the product by its gripping
surface .
¾
Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles .
¾
Secure the product to prevent it from slipping
or falling over .
˜
Troubleshooting
m
WARNING!
u
Only perform the steps described within
these instructions! All further inspection,
maintenance and repair work must be
performed by an authorised service centre
or a similarly qualified specialist if you
cannot solve the problem yourself!
Suspected malfunctions are often due to causes
that the users can fix themselves . Therefore check
the product using this section . In most cases the
problem can be solved quickly .
Problem Possible cause Solution
Product
does not
start
Not connected to
power supply
Connect to
power supply
Power cord or plug
is defective
Check by
a specialist
electrician
Other electrical
defect to the
product
Check by
a specialist
electrician
Product
does not
reach full
power
Power source
(e .g . generator) has
too low voltage
Connect
to another
power source
Air vents are
blocked
Clean the air
vents
Unsatis-
factory
result
Accessory is worn Replace with
a new one
Accessory not
suitable for intended
operation
Use suitable
accessory
˜
Service
m
WARNING!
u
Have your product repaired at the service
centre or an electrician, using only original
manufacturer parts . This will maintain the
safety of this product .
u
If the supply cord or plug is damaged, it
must be replaced by the manufacturer, its
service agent or similarly qualified persons
in order to avoid a hazard .