PFE 50 A1
GB
│
MT
│
37
■
♦
Press the on/off switch on the handle to start
the pump, drawing paint into the roller via the
hose (depending on the type of paint, this can
take up to 1 minute).
♦
Once the paint has reached the paint roller
and this has soaked with color, you can start
painting.
♦
Turn off the on/off switch
while painting.
♦
Press the on/off switch when you need to
re-color of the paint roller .
Work breaks of up to 4 hours
♦
Switch off the appliance.
♦
Place the paint roller immediately into a
plastic bag and tie it air-tight.
♦
Leave the intake hose in the paint.
Longer work breaks
♦
Switch off the appliance.
♦
Place the paint roller in a bucket filled
with water.
♦
Leave the intake hose in the paint.
♦
Sprinkle a little water onto the surface of the
paint in the paint container to stop it from form-
ing a skin.
Shutting down and cleaning
Thorough cleaning is essential for proper
operation of the paint application appliance.
No warranty claims will be accepted for
insufficient or improper cleaning.
NOTE
►
Only use water for cleaning. Ideally, use luke-
warm water with a little dishwashing liquid.
♦
Switch off the appliance on the main switch
(“O”).
♦
Scrape the paint roller off on the edge of
the paint container.
♦
Remove the paint roller by pressing the
locks on the roller bracket .
♦
Hold the paint roller firmly with a cloth
and push the cap downwards to lever it out
(see fig. G). Pull the inner roller out of the
paint roller .
♦
Clean all parts of the paint roller in luke-
warm water.
♦
Hang the end of the intake hose in a bucket
of water (see fig. H).
♦
Switch on the appliance on the main switch
(“I”).
♦
Hold the roller bracket over the paint bucket
and press the on/off switch to pump the
paint out of the hose into the paint bucket (see
fig. I).
♦
Switch the pump off again as soon as water
starts coming out of the roller bracket .
♦
Hang the roller bracket in a bucket of water
(see fig. J). If available, you can also hang the
roller bracket in an empty bucket. This will
prevent dirty water from being pumped back
into the system and improves the cleaning
effect.
♦
Press the on/off switch to start the self-
cleaning process. Circulate water through the
appliance for about 10 minutes to clean it. If
necessary, replace the water.
NOTE
►
It is possible that minor paint residues remain
in the hose. This is normal and has no nega-
tive influence on future work.
CAUTION!
►
After cleaning, pump all of the water out of
the appliance and the hose. If any water
remains in the pump, there is a risk of ice
damage if the temperature falls below 0°C.
♦
Remove the roller bracket from the handle .
♦
Wipe all parts thoroughly to assure proper
functioning.
