Parkside PFBS 160 B2, Original Instructions Manual

Page: 12 / 214

PFBS 160 B2
GB
│
IE
│ 9 ■
■ Always purchase the correct cell or battery for
an appliance.
■ Keep cells and batteries clean and dry.
■ If the terminals of the cells or batteries are
contaminated, clean them with a dry, clean
cloth.
■ Store the original instructions and information
about the products safely for future information
and reference purposes.
■ Cells and batteries may not be used in applica-
tions for which they are not designed.
■ Always remove batteries from appliances that
are not in use, if possible.
■ Do attempt to recharge non-rechargeable
batteries.
There is a risk of explosion!
Original accessories/auxiliary
equipment
■ Use only the accessories and auxiliary equip-
ment that are specified in the operating instruc-
tions and are compatible with the appliance.
Operation
Changing/inserting the tool/collet
chuck
♦ Press the spindle lock and hold it down.
♦ Turn the tensioning nut until the lock clicks
into place.
♦ Undo the tensioning nut from the thread
using the combination spanner .
♦ Remove any attached tool.
♦ First push the intended tool through the
tensioning nut before inserting it into the
appropriate collet chuck for the tool
shaft.
♦ Press the spindle lock and hold it down.
♦ Push the collet chuck into the thread insert
and screw the tensioning nut tight with the
combination spanner .
Using an accessory tool with a mandrel
♦ Use the screwdriver side of the combination
spanner to undo and tighten the screw on
the mandrels or .
♦ Insert the respective mandrel , or into
the appliance as described.
♦ Use the combination spanner to undo the
screw on the mandrel or .
♦ Insert the desired accessory tool between the
two washers on the screw.
♦ Use the combination spanner to tighten the
screw on the mandrel or .
Whet stone
♦ Do not manually grind any edges with the whet
stone .
Fitting abrasive belts
♦ Push the abrasive belt onto the abrasive
belt mandrel . Tighten the screw on the abra-
sive belt mandrel in order to fix the abrasive
belt .
Fitting polishing attachments
♦ Screw the polishing attachment onto the tip
of the mandrel for polishing attachments .
Switching on and off/setting speed
range
CAUTION!
■ The rotation direction can be read off the
arrow engraved on the union nut (anti-
clockwise symbol).
Switching on/setting the speed range
♦ Set the ON/OFF switch to the "I" position.
♦ Set the speed control to a position between
"1" and "MAX".
Switching off
♦ Move the ON/OFF switch to the position
"O".