PFBS 160 B2
■
86
│
DE
│
AT
│
CH
■
Beachten Sie die Daten und Informationen in
der Tabelle, um zu verhindern, dass das Spin-
delende den Lochboden des Schleifwerkzeugs
berührt.
Flexible Welle
■
Bedienen Sie die Spindelarretierung nie bei
laufendem Motor. Das Gerät oder die flexible
Welle können ansonsten beschädigt werden.
♦
Schrauben Sie die Überwurfmutter vom
Gerät entgegen der Uhrzeigerrichtung ab und
bewahren Sie diese auf.
♦
Betätigen Sie die Spindelarretierung und
halten Sie diese gedrückt.
♦
Schrauben Sie die Spannmutter vom Gerät
entgegen der Uhrzeigerrichtung ab.
♦
Die Welle muss ein Stück rausgezogen werden
da sie sonst nicht in der Spannzange ,
fixiert werden kann.
♦
Montieren Sie die flexible Welle auf das
Gerät. Dabei muss die Innenachse der flexiblen
Welle zusammen mit der Spannmutter in die
Spannzange , eingesetzt werden.
♦
Betätigen Sie die Spindelarretierung und
halten Sie diese gedrückt.
♦
Drehen Sie jetzt die Spannmutter mit dem
Kombischlüssel fest.
Drehen Sie nun die Überwurfmutter
14b
der
flexiblen Welle auf dem Gerät in Uhrzeiger-
richtung fest.
♦
Setzen Sie jetzt das gewünschte Zubehörteil in
die Spannzange , der flexiblen Welle ein.
♦
Schieben Sie zum Arretieren der Spindel die
Spindelarretierung an der flexiblen Welle
zurück.
♦
Öffnen Sie mit dem Kombischlüssel die
Spannmutter an der flexiblen Welle. Setzen
Sie das Zubehörteil ein und schrauben Sie die
Spannmutter wieder fest.
Stativ für das Multifunktionswerkzeug
♦
Schrauben Sie das Stativ in die Klemmvor-
richtung .
HINWEIS
►
Je nach gewünschter Befestigung an einer
waagerechten oder senkrechten Fläche
können Sie das Stativ in zwei unterschied-
lichen Stellungen in die Klemmvorrichtung
einschrauben.
♦
Schrauben Sie die Klemmvorrichtung am
Rand einer Werkbank oder eines Arbeitstisches
fest, dessen Dicke höchstens 55 mm beträgt.
♦
Das Stativ ist höhenverstellbar. Lösen Sie das
obere Rohr des Stativs durch Linksdrehen (–).
Ziehen Sie das Rohr bis zur größten Höhe
heraus und arretieren Sie es wieder durch
Rechtsdrehen (+).
♦
Die Halterung ist ebenfalls höhenverstellbar;
drehen Sie das schwarze Gewinde nach links.
Nachdem Sie die Halterung in der richtigen
Höhe eingestellt haben, drehen Sie das Gewin-
de in umgekehrter Richtung wieder fest.
♦
Befestigen Sie das Gerät mit dem Metallbügel
an der Halterung des Stativs . Diese
Halterung lässt sich um 360° drehen.
Summary of Contents for PFBS 160 B2
Page 3: ...C A B 14b...