15
GB
Start-up
Store accessories inside the original box or oth-
erwise protect the accessories from damage.
Store accessories dry and away from aggres-
sive media.
Tips and tricks
Applying excessive pressure can cause the in-
stalled tool to break and / or damage the work
piece. Optimal results can be achieved by ap-
plying the tool to the work piece at a steady
speed range and little pressure.
Hold the device with both hands whilst cutting.
Please note the data and information in the
chart to prevent the spindle end touching the
perforated plate of the grinding tool.
Flexible shaft
Never use the spindle lock with the motor on.
The tool or the flexible shaft could otherwise
be damaged.
Unscrew the union nut
5
from the tool, turning
counter-clockwise, and put aside.
Press and hold the spindle lock
9
.
Unscrew the clamping nut
6
from the tool,
turning counter-clockwise.
Attach the flexible shaft
14
to the tool, inserting
the inner axle on the flexible shaft along with
the clamping nut
6
into the collet
7
,
26
.
Use the combination wrench
25
to first tighten the
clamping nut
6
, then the union nut
14 b
of the
flexible shaft
14
to the tool, turning clockwise.
Now insert the accessory you wish to use into
the collet
7
,
26
of the flexible shaft.
To lock the spindle, slide back the black sleeve
on the flexible shaft.
Using the combination wrench
25
, open the
collet holder
15
on the flexible shaft, insert the
accessory and tighten the collet holder
15
.
Stretch stand for the
multi-function tool (Fig. J)
Screw the stretch stand
17
into the clamp
18
.
Note:
The stretch stand
17
can be screwed
into the clamp in two different positions, de-
pending on the whether you‘re attaching to a
horizontal or vertical surface.
Secure the clamp
18
at the edge of a work-
bench or a work table no thicker than 55 mm.
The stretch stand
17
is height adjustable. Loosen
the upper tube of the stretch stand
17
by turning
to the left (–). Extend the tube to the maximum
height and secure by turning to the right (+).
The holder
16
is also height adjustable, simple
turn the black thread to the left. After adjusting
the holder to the correct height, turn the thread
in the opposite direction to tighten.
Secure the tool to the holder
16
of the stretch
stand
17
with the metal bracket
3
. This hold-
er
16
rotates by 360°.
Base assembly
Using the attachment, the tool is particularly suited
for cutting special shapes (holes for sockets, etc.).
Attach the milling bit
31
as described in chapter
„Attaching / changing the tool / collet“.
Ensure that the bit’s shaft protrudes from collet
by approx. 13 mm.
Unscrew the union nut
5
from the tool, turning
clockwise, and put aside.
Screw the base
13
onto the unit.
To set the correct working depth, loosen the
locking screw
12
and adjust the bottom of the
base assembly to the desired size.
Then tighten the locking screw
12
.
Start-up
