11
GB / IE / NI
socket.
Planing debris removal port (right /
left selectable):
□
Release the planing debris removal port 3
by turning it into the “Lock-off” position
along the direction of the arrow.
□
Pull the planing debris removal port 3 out
of the device.
□
The planing debris removal port 3 can be
set to face left or right in the planer.
□
Push the planing debris removal port 3
into the device.
□
Lock the planing debris removal port
3 by turning it into the “Lock” position
along the direction of the arrow.
External vacuum extraction:
If necessary fit the vacuum cleaner adapter
when using a dust extraction system, e.g.
a workshop dust extraction system.
The vacuum cleaner / dust extraction device
used must be suitable for the material being
planed.
Connection:
□
Place the vacuum cleaner adapter
firmly on to the planing debris removal
port .
□
Push the hose of a suitable dust extraction
device approved for that purpose (e.g.
a workshop vacuum cleaner) on to the
planing debris removal port or the
vacuum cleaner adapter .
Removal:
□
Pull the hose of the dust extraction device
off the planing debris removal port or
off the vacuum cleaner adapter .
□
Pull off the vacuum cleaner adapter ,
if fitted.
●
Parking shoe (see Figs. B / C)
The parking shoe allows you to lay the
device down without the risk of damaging
the workpiece.
When planing, the parking shoe swings
up and exposes the rear part of the sole .
●
The planing process
■
CAUTION! DANGER OF KICKBACK!
Always switch on the device before
placing it against the workpiece.
□
Set the required cutting depth.
□
Switch on the device.
□
Always place the front part of the sole
down first on to the workpiece.
□
Guide the device with even forward
movement over the surface being planed.
□
Move the device forward at a slow rate
and ensure that the contact pressure acts
evenly on the sole . Moving forward at
too great a rate results in a poorer surface
quality and can lead to blocking of the
planing debris removal port.
●
Chamfering edges (see Fig. H)
The V-grooves
10
in the front sole
9
allow
the device to be used for simple chamfering
of workpiece edges.
□
Use the V-groove most appropriate to your
desired chamfer width.
□
Place the planer with the V-groove on
the workpiece edge and guide the planer
along the edge.
●
Using the guide fence
(see Fig. I)
□
Attach the guide fence
6
to the device
with the fixing screw .
□
Release the fixing nut
8
and set the
guide at the desired distance.
□
Retighten the fixing nut
8
.
Preparing for use
3
3
3
3
3
3
3
3
7
9
9
9
10
15
15
15
15
15
16
16
