Parkside PDT 40 D3, Operation And Safety Notes

Page: 8 / 53

8 GB/CY
At the workplace, only carry the fas-
tener driving tool by its grip and never
with the trigger actuated.
Pay attention to workplace conditions.
Fasteners may strike completely through thin
workpieces or slide off corners or edges to
cause a danger to persons.
Use suitable personal protection equip-
ment, e.g. hearing and eye protection.
Wearing personal protective devices such as
dust mask, non-slip safety shoes, safety helmet
or hearing protectors, depending on the type
of fastener driving tool and its application, re-
duces the risk of injuries.
Additional safety information
for compressed air tackers
RISK OF INJURY!
Never
exceed the maximum permissible operating
pressure of 8 bar. Use a pressure reducer to
adjust the operating pressure.
RISK OF INJURY! Never
use oxygen or other flammable gases as ener-
gy source.
Keep your working area clean and
well lit.
Untidy or poorly lit working areas
can lead to accidents.
Keep children and other individuals
away from the fastener driving tool
during use.
Distractions can cause you to
lose control of the device.
Remain alert at all times, watch what
you are doing and always proceed with
caution when working with a fastener
driving tool. Do not use any fastener
driving tool if you are tired or under the
influence of drugs, alcohol or medication.
One moment of carelessness when using the fas-
tener driving tool may result in serious injuries.
Avoid placing your body in an unnat-
ural position. Keep proper footing
and balance at all times.
By doing this you
will be in a better position to control the fas-
tener driving tool in unforeseen circumstances.
Before any repair and maintenance work or
transport, remove the device from the com-
pressed air source.
RISK OF INJURY! Do not use the device on
scaffolds or ladders.
Never use hydrogen, oxygen, carbon
dioxide or other bottled gasses to
power this tool as doing so may re-
sult in an explosion and thus may cause severe
injuries.
RISK OF INJURY! Do not use the device if
the trigger lock
9
is damaged or has been
removed. Otherwise injuries may result.
When loosening the hose coupling, hold the
hose firmly in your hand to prevent injuries
caused by a rebounding hose.
Be absolutely certain to use a ¼ threaded
nipple and a quick-release coupling for the
compressed air connection.
Never place your hands near the mouth when
the device is ready to operate. Otherwise inju-
ries may result.
Pay attention to damage. Check the de-
vice for damage before bringing it into use. If
the device exhibits defects, it must not be oper-
ated under any circumstances.
Do not use any pointed objects. Never
insert pointed and / or metal objects into the
inside of the device.
Only connect the air-powered staple gun to
lines which are guaranteed not to exceed the
maximum operating pressure by more than
10 %, e.g. with a pressure control valve in the
compressed air line (pressure regulator) with
downstream or built-in pressure limiting valve.
When using the air-powered staple gun be sure
not to exceed the max. pressure.
Only operate the air-powered staple gun at the
pressure required for the respective operation
to prevent needlessly high noise levels, increased
wear and malfunctions this causes.
FIRE AND ExPlOSION
hAzARD! Never pressurise the air-powered
staple gun with oxygen or flammable gasses.
Safety of the fastener driving tool Safety of the fastener driving tool / Preparing the product for use / Operation