![background image](http://html2.mh-extra.com/html/parkside/pdsp-1000-b2/pdsp-1000-b2_translation-of-the-original-instructions_3856221010.webp)
■
6
│
GB
│
IE
PDSP 1000 B2
■
The nearer you are to the workpiece, the
smaller the dispersion pattern and vice versa.
■
Do a test run on an old workpiece to find out
the correct distance/working pressure and
avoid excessive reflection from your workpiece.
Switching on:
■
Set the control dial to "1" to open the air
outlet.
■
Move the compressed air sandblaster close
to the area to be worked.
■
Press the trigger to start operating the com-
pressed air sandblaster gun .
Switching off:
■
Release the trigger to switch off of the com-
pressed air sandblaster gun .
■
Set the control dial to "0" to close the air
outlet.
■
Disconnect the appliance from the compressed
air source after you finish work.
NOTE
►
First detach the hose from the compressed air
source before disconnecting the supply hose
from the appliance.
In this way, you avoid uncontrollable thrash-
ing about of the supply hose.
Collecting bag for sandblasting
material
NOTE
►
Do not re-use surplus sand-blasting material
from the collecting bag until it has been
cleaned.
■
You can remove the surplus sand-blasting mate-
rial which has collected in the collecting bag
via the zip fastener or use a screwdriver to undo
the screw clamp and remove the collecting
bag from the appliance.
Troubleshooting
Fault/possible cause
Remedy
No material flow
The air is not dry
enough.
Install a water separa-
tor in your compressed
air system.
Air pressure too low
Increase the output
pressure of your com-
pressor.
Attachment not sitting
correctly
Ensure that the attach-
ment is firmly on the
appliance and that
no air escapes at the
sides.
Blocked sand-blasting
material pipes
Check that no lumps of
sandblasting material
are blocking the pipes.
Preferably, use a
blow-out gun to clean
blocked pipes.
(
Wear safety gog-
gles!
) Also check the
tank outlet opening.
Sand-blasting pattern not as expected
The air is not dry
enough.
Install a water separa-
tor in your compressed
air system.
Sand-blasting material
grain size not uniform
Replace sand-blasting
material.
Sand-blasting material
impure
Clean/replace sand-
blasting material
The attachment is worn Replace the attach-
ment
Other defects
Please contact an expert or your retailer.
Summary of Contents for PDSP 1000 B2
