Parkside PBSG 95 A1, Operator'S Manual

Page: 8 / 40

8 GB/IE
Use General safety advice
Before the electrical power tool is used, carefully
check the safety equipment and any slightly
damaged parts to see that they are still work-
ing properly.
Check that all moving parts on the tool are
working properly, can move freely and are not
damaged. All parts must be correctly attached
and fulfil all the requirements necessary to allow
the electrical power tool to operate properly.
Damaged safety equipment and components
must be properly repaired or replaced at a
competent electrical equipment repair centre
unless otherwise indicated in the operating in-
structions.
Damaged switches must be replaced at a
Customer Service Centre.
Never use an electrical power tool that cannot
be switched on and off properly.
21. CAUTION!
The use of inserted tools and accessories other
than those recommended by the manufacturer
could lead to you being injured.
22.
Have your electrical power tool
repaired at an electrical equipment
repair specialist.
This electrical power tool complies with the
relevant safety regulations. Repairs may only
be carried out by a specialist electrical repair
centre using original spare parts, otherwise
injury could occur to the user.
Q
Device-specific safety instruc-
tions for drill sharpeners
Make sure that the device is switched
off before inserting the mains plug
into the socket.
Always pull the mains plug out before
carry out cleaning or maintenance
work.
This is to prevent the device starting up
by accident.
The ventilation openings
10
of the mo-
tor unit must always be kept clear.
Otherwise there is a risk of the device overheating.
When carrying out work on the device
as well as transporting or storing it,
move the ON / OFF switch
4
to the
“0” position (off) in order to prevent
it switching itself on by accident.
FIRE HAZARD DUE TO FLYNG SPARKS!
Grinding metal will cause sparks to fly. That is
why you should always make sure that no-one
is at risk from them and that no combustible
materials are located in the proximity of the
area of work.
RISK OF INJURY!
Use the
ON / OFF switch 4 to switch the grinder off
in the event of a power failure or when pulling
out the mains plug. This prevents the grinder restart-
ing by accident, which could cause injury to you.
Never operate the grinder if the power
cable or mains plug is damaged.
Grinding stones must be carefully
stored and handled according to the
manufacturer’s instructions.
Make sure that the grinding tools are
appropriate in line with the instructions
of the manufacturer.
Check the grinding stone before using
it;
do not use any broken, cracked or otherwise
damaged goods.
Make sure that a grinding tool is correct-
ly fitted and fastened before using it.
Place the grinder in a safe place and allow it
to run idly for 30 seconds. Stop it immediately if
considerable oscillations occur or if defects are
observed. If this occurs, check the machine to
find out the cause.
Q
Original accessories /
Attachments
Use only the accessories and attachments
detailed in the operating instructions.
The use of inserted tools or accessories other
than those recommended in the operating in-
structions could lead to you suffering an injury.