05
Congratulations on the purchase of your new
product. You have chosen a high quality quality
product with this purchase. These operating
instructions form an integral part of this Hammer
Drill (hereafter referred to only as the „drill“).
It contains important instructions on safety, use
and disposal of the product. Please familiarise
yourself with all operating and safety instructions
before using the product. Only use the product
as described and for the stated purpose. If the
product is passed on to a third party, please
provide all documents to the third party together
with the product.
The following symbols and key words are used in
this operating manual, on the hammer drill or on
the packaging.
Mains plug is inserted (green
indicator).
Carbon brushes worn out (red
indicator).
1. Introduction
Symbols used
Read the operating manual.
Products marked with this symbol
comply with all applicable
regulations of the European
economic area.
Protection category 2
The „GS“ symbol stands for verified
safety. Products that are marked with
this symbol meet the requirements of the
German product safety law (ProdSG).
The model name on the hammer drill is a
combination of letters and numbers:
PBH 1500 F6
=
Hammer drill
Indicates a hazard that, if not avoided, could
result in death or serious injury.
WARNING!
Signals a hazard that can cause injuries when
ignored.
CAUTION!
Warns against possible damages.
NOTE!
≥
100
A
The hammer drill is intended for use
only in places that have a
continuous current rating of ≥ 100 A
per phase and are supplied with a
rated voltage of 230 V by the
distribution network.
Scope of delivery
• Hammer drill
• Keyed chuck
• Chuck key
• Depth stop
• Key for lubrication of the housing cover
• Accessories (suitable for use with SDS+ system)
- 1 pointed chisel
- 1 flat chisel
- 3 drill bits (12, 16 & 18 mm)
