16 GB/IE
Note:
If the product has not been charged for an extended period
of time (approx. 2 months), you could find that the integral recharge-
able battery has entered a dormant state. Charge and discharge the
product a number of times in succession to reactivate the integral
rechargeable battery.
Connect the USB cable
10
with the USB connector of the mains
adapter
8
or the car adapter
9
.
Connect the micro-USB connector on the USB cable
10
to the
micro-USB input socket
6
on the product.
Plug the mains adapter
8
into a socket, or plug the car adapter
9
into the cigarette lighter socket in your vehicle.
Note:
During charging from a cigarette lighter socket, ensure
that the car adapter is always completely inserted into the ciga-
rette lighter socket of the vehicle. Failure to observe this advice
may result in risk of fire from overheating.
Note:
The product has an overcharging protection system.
Nevertheless, you should disconnect the product from the mains
once the charging process is complete.
Note:
The charging indicator
5
illuminates red during the
charging process. When the charging process is complete, the
charging indicator
5
illuminates green. When the charging
indicator
5
illuminates green, pull the mains adapter
8
out
of the mains socket or the car adapter
9
out of the cigarette
lighter socket. Disconnect the mains adapter
8
or the car
adapter
9
from the product to prevent the rechargeable battery
from discharging themselves.
Use
CAUTION – RISK OF ACCIDENT!
If at all possible, do not use
the product in a moving vehicle. If the product is used in a vehicle, it
must not be allowed to endanger the safety of the driver or passengers.
Always store and secure the product in such a way that there is no
risk of injury from or damage to the product, even during full braking.
Note:
You can secure the product by using the hook
1
or the mag-
netic base
4
on a flat, ferromagnetic surface. Use the joint
7
to tilt
the product up to 180° on the magnetic base
4
. The strip light
2
can be rotated to a desired angle.
CAUTION!
Please note the position of your hands whilst turning the
magnetic holder to prevent pinching your fingers (see Fig. C).
Using the product disconnected from
a power supply
Fully charge the product, as described in the section on
“Charging the product”.
The product can be operated in 3 different modes, select these by
repeatedly pressing the ON / OFF switch
3
.
press once:
The strip light
2
lights up at full power.
press twice:
The strip light
2
lights up at low power.
press three times:
Switches off the product.
Troubleshooting
Fault
Possible causes and cures
No functions - Mains adapter
8
or car adapter
9
is not fully
inserted.
- Check the mainpower socket can be functioned
properly.
- Check the house's fuse.
Summary of Contents for PATC 2 A1
Page 3: ...A 7 1 4 8 9 10 3 2 B 5 6 C...
Page 4: ......
