Parkside PASSK 20-Li A1, Translation Of The Original Instructions, Page: 12 / 126

PASSK 20-Li A1
GB
│
IE
│ 7 ■
ATTENTION! Hot surface .
There is a risk of burns .
Before use
Charging the battery pack (see fig . A)
CAUTION!
► Always pull out the power plug before you
remove the battery pack from or connect the
battery pack to the charger .
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level
is between 50% and 80% . The storage cli-
mate should be cool and dry and the ambi-
ent temperature should be between 0°C and
50°C .
♦ Connect the battery pack to the high-speed
battery charger (see Fig . A) .
♦ Insert the power plug into the socket . The green
charge control LED lights up briefly, then the
red charge control LED lights up .
♦ The green LED indicates that the charging
process is complete and the battery pack
is ready for use .
CAUTION!
♦ If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged .
♦ If the red and green control LEDs both
flash, this means that the battery pack is
defective .
♦ Push the battery pack back into the appliance .
♦ Switch off the charger for at least 15 minutes
between successive charging sessions . Also dis-
connect the power plug from the mains power
socket .
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Push the rotation direction switch into the
middle position (lock) . Push the battery pack
into the handle until it clicks into place .
Removing the battery pack
♦ Press the release button and remove the
battery pack .
Checking the battery charge level
♦ Press the battery charge level button to
check the status of the battery (see also main
diagram) .
The status/remaining charge will be shown on
the battery display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Use
Switching on and off
Switching on
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in .
The LED working light lights up when the
ON/OFF switch is depressed lightly or fully .
This provides illumination of the work area in
poor lighting conditions .
Switching off
♦ Release the ON/OFF switch to switch off the
appliance .
Setting/preselecting the rotation
speed/tightening torque
♦ Press the torque preselection button to select
the required torque in stages .
♦ Press the ON/OFF switch lightly for a low
speed/tightening torque . Increasing the pres-
sure increases the speed/tightening torque .
■ The tightening torque depends on the selected
speed/torque preselection and impact duration .