GB
│
IE
│
NI
│
7
■
PAS 4 B2
Before use
Charging the appliance battery
(see fig . A)
NOTE
►
The battery is supplied partially charged .
Before first use, charge the battery in the
charger for at least 1 hours . This guarantees
full battery power . Li-ion batteries can be
charged at any time without adversely
affecting their service life . Interruption of the
charging process will not damage the
battery .
►
If the battery charge level indicator lights
up red during use, the battery is at less than
30% of its capacity and needs to be
charged .
►
Never charge the cordless appliance when
the ambient temperature is below 10°C or
above 40°C . If a lithium-ion battery is to be
stored for an extended period, the charge
level should be checked regularly . The
optimum charge level is between 50% and
80% . The storage climate should be cool and
dry and the ambient temperature should be
between 0°C and 50°C .
Start charging:
♦
Connect the charger to a 100–240 V ∼
50/60 Hz power source .
♦
Connect the charger to the charging socket
on the device .
The battery is fully charged when the battery level
indication changes from red to green .
Stop charging:
♦
Disconnect the charger from the mains
power supply .
♦
Disconnect the charger from the charging
socket on the device .
Assemble the attachments
Usage:
- With the torque attachment screwing stops as
soon as the screw is tight . Set the required torque
from one of the 10 levels .
- The eccentric attachment allows you to screw
even in locations that are close to the wall .
- The angle attachment allows you to screw at
right angles .
- The cutting attachment allows you to cut soft
materials, such as card and similar materials up to
a thickness of 6 mm .
Assembly:
NOTE
►
Before carrying out any work on the appli-
ance, ensure that the rotation direction switch
is in the middle . This prevents unintentional
switching on .
♦
Start by removing the rubber cap from the tool
holder (see fig . B) .
♦
Now you can fit the supplied attachments to the
appliance in 45° steps . Fit the attachment onto
the appliance so that the attachment clicks into
place . (see fig . C, example: torque attachment
) .
Dismantling:
♦
To remove the attachments from the appliance,
press the release button and pull the attach-
ment off forwards .
♦
Afterwards, replace the rubber cap on the tool
holder .
Summary of Contents for PAS 4 B2
Page 3: ......
Page 4: ...A B C D F E I II III...