PAK 20-Li A1 / PALP 20-Li A1
GB
│
IE
│
23
■
Operating the cordless
compressor PAK 20-Li A1
This appliance is not designed for continuous
operation. The appliance may be used for a maxi-
mum of 10 minutes continuous operation. If the
appliance overheats, remove the battery pack .
Allow the appliance to cool down completely and
then try using it again.
Display indicator
♦
Press the ON/OFF switch on the display
or press the ON/OFF switch to switch on
the display indicator .
♦
The last set pressure is displayed for 2 seconds.
♦
After two seconds, the current pressure of the
connected item is shown.
NOTE
►
If the compressed air hose is not connected
to a suitable item, the display indicator
shows "0".
♦
If the display indicator is switched on, you
can switch between "bar" and "psi" by pressing
the ON/OFF button .
♦
To switch off the display indicator , press the
ON/OFF button for 3 seconds.
NOTE
►
The compressor will not work if the display
indicator is switched off.
Setting the pressure
♦
Hold down the "+" or "–" button until the
display flashes.
♦
Press the "+" or "–" button to set the
desired pressure.
♦
Once you see the desired pressure on the
display indicator , do not press any button
for about 3 seconds.
The desired pressure is now set.
NOTE
►
The display indicator (and thus the com-
pressor) switches off after around three
minutes of inactivity.
TIP
►
If you press and hold the "+" or "–"
button, the pressure changes quickly.
Initial operation
♦
Loosen the cap nut (do not unscrew it com-
pletely!), twist in the compressed air hose
threaded connection
22a
and retighten the
cap nut .
♦
Select the desired pressure.
♦
Insert one of the supplied adapters ( , , ,
, , ) tightly onto the compressed air hose
adapter .
♦
Connect the adapter , , , , or
to the object to be inflated.
♦
Press the ON/OFF switch .
♦
The compressor switches off automatically when
you reach the preset pressure.
♦
Pull the adapter , , , , or out of
the now inflated item.
