Parkside PAH 1300 B2, Translation Of The Original Instructions

Page: 39 / 54

PAH 1300 B2 ■ 36 │
GB
│
MT
Installation
Additional handle
♦ You can position the additional handle as
you wish.
♦ Undo the knurled nut .
♦ Swing the additional handle around the
appliance axis or 180° forward or backward
into the desired position (see foldout page).
♦ Retighten the knurled nut .
Fitting a tool
The supplied grease is solely for greasing
the tool holder .
♦ Pull the locking sleeve backwards.
♦ Before fitting a tool into the tool holder ,
grease it lightly.
♦ Insert the tool with a rotating movement in the
tool holder until it clicks into itself.
♦ Release the locking sleeve .
This locks the holder.
Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.
Removing a tool
♦ Pull the locking sleeve backwards and pull
the tool out of the tool holder .
Adjust chisel position
♦ You can adjust the flat chisel in optimal
working position.
♦ Place the flat chisel into the tool holder .
♦ Push the chisel adjustment ring forward and
turn with the chisel adjustment ring the flat
chisel to the required position.
♦ Release the chisel adjustment ring and turn it
until it clicks.
Operation
Switching on and off
During operation, you can choose between
instantaneous and continuous operation.
Switching to instantaneous operation
♦ Press the ON/OFF switch .
Switching off instantaneous operation
♦ Release the ON/OFF switch .
Switching to continuous operation
♦ Press the ON/OFF switch and lock it in this
position with the locking switch .
Switching off continuous operation
♦ Press the ON/OFF switch and release it
again.