Parkside KH 4125 DRILL-POWERED WATER PUMP, Operating Instructions Manual

Page: 6 / 17

- 4 -
Insert the spindle shaft of the electric drill
r
into the mounting
e
.
Now slide the pump
q
onto the mounting
e
so that the drive axle of the
pump extends into the drill chuck, and the pegs of the mounting
e
are
inserted into the receptor holes on the pump
q
.
Through the recess
t
, turn the drill chuck with the chuck key so tight that
the pump cannot be detached from the mounting.
Securely tighten the cross-head screw on the mounting
e
so that the drill
is being firmly held .
Connect the suction hose to connection
y
and the pressure hose to
connection
u
.
Utilisation
Insert the open end of the suction hose into the fluid to be drained/
transferred. Suction is only possible if ...
– the suction hose does not draw air and is not longer than 12 meters
(ca. 39 feet), and
– the pressure hose is open during suction.
Now allow the electric drill to drive the pump – but not without super-
vision, so as to be able to react quickly in the event of danger. Make
absolutely sure that the drill revolves to the right, just as in drilling. Should
the drill-speeds be adjustable, you can adjust the work capacity with
them.
IB_KH4125_BK23666_LB3B 24.06.2008 16:12 Uhr Seite 4