![background image](http://html1.mh-extra.com/html/parkside/amfw-20-li-a1/amfw-20-li-a1_translation-of-the-original-instructions_4030751027.webp)
PAMFW 20-Li A1
GB
│
IE
│
23
■
Fitting the sanding sheet onto the
sanding plate
♦
Place the sanding sheet centrally on the
sanding plate .
Changing tools
NOTE
►
If you plan to use the dust extraction unit, it
must be connected before fitting or changing
the tool (see. section "Connecting a dust
extraction unit").
WARNING! RISK OF INJURY!
■
Always remove the battery before working on
the power tool.
♦
If necessary, remove an already fitted tool.
To do this, raise the tool release lever .
♦
Fit the tool (e.g. the plunge saw blade ) onto
the tool holder.
NOTE
►
You can fit the tools in any snap position on
the tool holder.
♦
Lock the tool into place by pushing the tool
release lever back down again.
■
Check that the tool is fitted firmly.
Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury.
Use
Switching on and off
Switching on:
♦
Push the ON/OFF switch forwards to switch
the appliance on.
The LED work light lights up when the appli-
ance is switched on to light up the working area
in low light conditions.
NOTE
►
The LED work light can only be used when
the dust extraction unit is not fitted.
Switching off:
♦
Push the ON/OFF switch backwards to
switch the appliance off.
Selecting oscillation speed
♦
Use the speed adjustment wheel to set the
required oscillation speed.
Level 1: low speed
♦
Level 6: high speed
NOTE
►
The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests.