30 GB
… / Cleaning and care / Information about warranty and service processing
Preparations for use
Clean dusty surfaces so that the suction cups can grip
well. Otherwise a slight shift in position is possible.
Connecting the airbrush set
Be absolutely certain to disconnect the mains
plug before connecting the airbrush set to the
compressor and release the pressure in the lines
by actuating the vent of the air blow gun
9
.
Use the respective screw connection to connect
the spray stylus
3
with the coiled hose
2
and
the coiled hose to the airbrush connection
1
.
Use the included open-end wrench.
13
(see Ill. A).
Fasten the paint mixing beaker with connection
lid
5
to the spray stylus
3
(see Ill. B).
Insert the mains plug into the mains socket.
Note:
For optimal results, professionals connect
an intermediate pressure reducer (not included
with delivery). The pressure reducer can be used
to adjust the compressed air at the spray gun
and optimise it to your needs.
Mixing paints for use
The paints included are water-soluble. In order to
properly apply the paints, add water and stir. As
delivered, the paints are too viscous.
First fill the beaker with your selected paint
colour with water.
Now screw the cover back on the beaker and
shake it.
Now remove two full droppers (1.5 mark on
the dropper) and fill these into a mixed glass
filled half way with water.
Shake the beaker. Now your paint has reached
the correct consistency.
Attach the paint mixing glass
5
according
to Ill. B.
Note:
If desired, you can adjust the amount of
water added to influence the colour intensity
yourself as with a watercolour box. The more
water you add, the „thinner“ the colour.
You can also mix individualised colour tones
from the available colour pastes. Please take
note, there must be no paint clumps remaining
in the paint containers. The consistency should
correspond to that of water.
Note:
If the paint used does not cover well, in-
crease the amount of paint in the mixture ratio.
Turning airbrush compressor
on / off
Turn the airbrush compressor
1
on by setting the
on / off switch
14
to the position “I“ (see Ill. C).
Turn the airbrush compressor
1
off by setting
the on / off switch
14
in the position “0“ (see
Ill. C).
Note:
Full pressure is built up after two seconds.
Regulating the air pressure
Regulate the air pressure by actuating the vent
of the air blow gun
9
to more or less of an
extent.
ATTENTION!
The device has a pressure switch,
which periodically and automatically turns the de-
vice off if there is excess pressure or if it is not in use.
Shortly before reaching the switch-off point, the
compressor runs more roughly and vibrates. This
may also be the case when re-started under load.
The performance and functionality are not impaired
by this. This is not a defect, rather, serves to protect
the compressor from overloading.
Regulating the spraying results
Regulate the amount of the paint supplied by
turning the paint nozzle of the spray stylus to
the right or left (see Ill. B).
Connecting the air hose
Connect the air hose
8
to the airbrush compres-
sor
1
. Use the included open-end spanner
13
to do so (compare Fig. A).
96759_par_Airbrush_Set_Content_DE_AT_NL.indd 30
28.04.14 09:11
