![background image](http://html1.mh-extra.com/html/parkside/391511-2201/391511-2201_translation-of-the-original-instructions_758366011.webp)
POF 1200 D3
GB
│
IE
│
7
■
Changing the collet chuck
NOTE
►
All of the cutters in the supplied cutter set are
equipped with an 8 mm shank.
Use the pre-assembled collet chuck (8 mm)
with them. When using milling cutters with a
6 mm shank, replace the collet chuck as
described below.
♦
Press the spindle locking button and hold it
down.
♦
Undo the union nut anticlockwise with the
open-ended spanner
until the collet chuck
(8 mm) can be removed.
♦
Fit the collet chuck (6 mm).
ATTENTION! Do not tighten the union nut
with the open-ended spanner unless a milling
tool is fitted. Otherwise, the collet chuck may be
damaged.
♦
Release the spindle locking button .
Fitting the rip fence
♦
Undo the wing screws for the sliding rods.
♦
Push the sliding rods into the corresponding
openings next to the wing screws. Retighten the
wing screws for the sliding rods.
Setting up
Switching on and off
Switching on
♦
Press the safety lock-out and hold it down.
♦
Press the ON/OFF switch . Once the
machine is running, you can release the safety
lock-out .
Switching off
♦
Release the ON/OFF switch .
Preselecting the rotation speed
♦
Set the required speed using the adjusting
wheel for speed preselection .
1–2 = low speed
3–4 = average speed
5–7 = high speed
Setting the milling depth
♦
Make sure that the clamping lever is locked.
If it is released, turn it anticlockwise until it is
locked.
♦
Place the appliance onto the workpiece.
♦
Rotate the step stop until it engages in the
lowest position (0 mm).
The depth stop is now in line with the lowest
position (0 mm).
♦
Undo the locking screw .
♦
Release the clamping lever by turning it
clockwise and pushing the appliance down-
wards until the milling machine is touching the
surface of the workpiece.
♦
Lock the clamping lever by turning it anti-
clockwise.
♦
Slide the depth stop downwards until it
reaches the lowest position (0 mm) of the step
stop .
♦
Set the depth stop to the desired milling
depth, tighten the locking screw .
NOTE
►
The values shown on the milling depth adjust-
ment scale do not correspond to the
actual milling depth. It should always be set
relative to a selected point on the milling
depth adjustment scale .
♦
Now, release the clamping lever and raise
the appliance again.
♦
Check the milling depth by means of a practical
test.
Summary of Contents for 391511 2201
