Parkside 373204 2104, Translation Of The Original Instructions

Page: 8 / 64

PDST 10 B3
GB
│
CY
│ 5 ■
1 . Use the pivoting mounting bracket
2
as a
template . You can disconnect the mounting
bracket
2
from the compressed air hose reel
after you have removed the two screws
8
by
turning them anticlockwise (see fig . C) .
Mark the position of the holes on the support
material with a pencil .
2 . Drill the holes required for mounting in the
support material .
3 . Mount the mounting bracket
2
with suitable
fixing material (see mounting accessories
0 q
) .
4 . Reattach the compressed air hose reel to the
mounting bracket
2
.
To do this, screw the screws
8
that you
removed in step 1 back in clockwise (see
Figure C) .
Commissioning
Connecting the compressed air hose
reel to a compressed air source
♦ Plug the compressed air connection
7
of the
compressed air hose reel into the quick coupling
of the compressed air source .
Connecting the compressed air hose
reel to a compressed air tool
NOTE! RISK OF DAMAGE!
► Improper handling of the compressed air
hose reel can lead to damage .
■ Never exceed the maximum working pressure
of the compressed air hose reel and ensure that
the connectors used are compatible .
The compressed air hose can be immediately
connected to the compressed air tool via the air
inlet of the compressed air tool using the quick
coupling
6
.
Using the compressed air hose reel
WARNING! RISK OF INJURY!
► The compressed air hose reel is equipped
with a return mechanism . This is operated by
a strong spring . If the compressed air hose
5
rolls up incorrectly, injuries may occur .
■ Never allow the compressed air hose
5
to
spring back in an uncontrolled way .
■ If the return mechanism is damaged, stop using
the compressed air hose reel immediately .
Have the damage repaired by a specialist .
■ The compressed air hose reel has a locking and
return mechanism . This makes it easy to pull out
and return the compressed air hose
5
.
■ The locking device generates a clicking noise
when rolling up and unrolling . This is not a fault .
If the noise changes after using the equipment
numerous times and/or if there are problems
with the mechanism, seek expert assistance or
contact customer service .
Unrolling the hose
♦ Pull the compressed air hose
5
carefully out
of the drum housing to the desired working
length for the pneumatic tool . If you release
the compressed air hose
5
after a click, the
locking device engages at this length .
Rolling up the hose
♦ A short pull on the compressed air hose
5
releases the lock .
♦ Make sure that the compressed air hose
5
rolls
back into the drum housing
1
in a controlled
manner .