Parkside 373100 2104, Operation And Safety Notes

Page: 10 / 72

10 GB
Do not use the maximum/minimum length
levers
[ 15] [ 16]
routinely as a stop mechanism .
These levers serve as a stop mechanism only
in emergencies .
Before you begin: Check whether
–
the steel cable
[ 14]
is wound properly
around the drum
[ 17]
and whether
–
the space between coils is less than the
diameter of the cable itself (Fig . D) .
˜
Before first use
Remove the packaging materials .
Remove the transport lock from the steel cable
[ 14]
. Cut the rubber band and remove it .
Before you begin: Check whether
–
the steel cable
[ 14]
is wound properly
around the drum
[ 17]
and whether
–
the space between coils is less than the
diameter of the cable itself (Fig . D) .
Make sure the steel cable
[ 14]
passes the
maximum/minimum length levers
[ 15] [ 16]
properly and without touching them (Fig . B) .
˜
Assembly
(Fig . E)
m
DANGER!
u
The square tube (cross sectional
dimensions: 45 x 45 mm) must be able
to bear a minimum load of 500 kg at
the points where the product is fastened .
It is recommended to consult qualified
personnel (for example a structural
engineer) for assembly .
u
Because special knowledge is required,
seek advice from a qualified technician to
ensure all screws are tightened fully and
correctly .
u
A qualified technician or a properly trained
person should also check the anchoring
of the square tube before the product is
fastened .
u
Time needed for assembly: approx . 1 hour
Fasten the product with the mounting brackets
[ 1]
and the mounting screws
[ 2]
to a suitable
square tube .
Tighten the mounting screws
[ 2]
.
˜
Operation
NOTE
u
The product has been outfitted with a
thermostat switch . During operation, it may
stop the motor
[ 3]
. The motor can be only
started again once it has cooled down .